There are two key points in the assembly of thrust ball bearings. One is the control of the pressing quality of the cage and the steel ball, and the other is the control of the nominal height T after the assembly of the bearing. In addition, since the shaft ring and the seat ring can be separated, there is a management problem. It is to prevent the mixing of imported bearing parts. The M-type press cage uses a curved edge assembly die. After pressing, the steel ball is required to rotate flexibly in the pocket hole, but it can not fall off from the pocket hole, and the technical procedure to check the momentum of the steel ball in the pocket hole. If the solid cage is imprinted too deeply, the momentum of the steel ball will be small, and the connection between the embodiments and the cage is too little and the strength is insufficient, which is easy to fall off and cause the cage to be scrapped.
Small thrust ball bearing seat ring and shaft ring inner diameter size difference is very small, there is no obvious difference between the two bundles. In order to prevent the phenomenon of mixed sleeves, that is, a set of bearings installed are found to be both seat rings or shaft rings. This requires certain measures. Usually, the drawing ring and the seat group are distinguished by auxiliary tooling when the set is closed, or the inner diameter plug gauge is used to check the inner diameter size before sampling the nominal height. In order to check the inner diameter, the seat ring is placed below and the shaft ring is placed above. If the inner diameter of the seat has obvious quenching heating oxidation color or is not grinding, there is no need to test the inner diameter size, and the difference between the shaft ring and the seat can be clearly seen, and it is not easy to mix. After assembling the thrust ball bearing, the nominal height T should be measured to confirm whether it is qualified. When measuring, calibrate with height block or standard parts, and measure the load, the bearing needs to rotate dozens of times, and be sure to reach the minimum height.
Features:
1. There are one-way and two-way types
2. In order to allow installation error, spherical aligning spherical cushion type or spherical ring type can be selected, whether one-way or bidirectional.
3. High quality steel - the use of ultra-clean steel can prolong the bearing life by up to 80%
4. High grease technology - lubricant technology can prolong the life of grease and improve the performance of bearings
5. High grade steel ball -- quiet and smooth when rotating at high speed
6. Use the ferrule in the selection to allow installation error.
Bearing role:
Its role should be to support, that is, literal interpretation used to bear the shaft, but this is only a part of its role, support its essence is able to bear radial load.
The lubrication method of bearings is divided into grease lubrication and oil lubrication. In order to make the bearing function well, first of all, it is necessary to choose the lubrication method suitable for the use conditions and purposes. If only lubrication is considered, the lubricity of oil lubrication prevails.
