13/04/2023
Distinguish the tight ring and loose ring of the bearing (according to the bearing inner diameter size judgment, the aperture difference of O.1 ~ O.5mm).
Distinguish the static parts of the mechanism (that is, the parts that do not move, mainly refers to the assembly).
No matter what the case, the loose ring of the bearing should always be on the end face of the static part.
13/04/2023
13/04/2023
There are many stamping forming processes used in production time, with various forms and names, but the essence of plastic deformation is the same. Stamping forming has the following very prominent characteristics.
13/04/2023
Heat treatment process generally includes heating, insulation, cooling three processes, sometimes only heating and cooling two processes.
13/04/2023
Support shaft journal
End cone hole
End short cone and end face
Empty gear journal
thread thread